I bought an electronic valve for a spare air line I brought into the machine, but I could not figure out how to get it to just shoot a burst of air. ![]() Is there a way to program a script or something in Mach4 that spins the face mill backwards at a low rpm and offsets it from the tool setter?Ĥ) The new tool setter has an air nozzle. Am I supposed to zero it out on the bed with a gauge block like I normally do, then use the Tool Setter for the other tools? Does the software take into account the location of where I probed with the gauge block and the fact the tool setter sits 4" above that?ģ) I run a 2" Face Mill in Tool Slot 2 always. For my probe I use a Haimer 3D Probe with dial gauge. I'm not sure what the best way to go about it is, but I felt like if it turned on the oil pump whenever it was running an operation, that would likely be suffecient to keep everything oiled, and then turned it off when the op was done? I'm not sure how to program that, or if it is possible.Ģ) I had another question, I just got in a new Auto Tool Setter today. I've accidentally left the oil pump running twice now. It came with a custom user interface and touch screen. If you let me know I can go pull them off the machine and upload them.ġ) The machine has an auto oiler and auto tool changer on it. I'm fairly inexperienced with Mach4, so I'm unsure what files I need to submit.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |